Pročitah nešto što nisam znao pa da pojasnimo neke stvari, možda još nekom zatreba.
Kada ruter povezujemo preko Client Mode, sa drugim ruterom, šerovanje je nemoguće jer kompjuteri nisu u istom subnetu.
Wireless, uređaja koji je u Client Modu, postaje postaje WAN interfejs.
Code:
This mode is NOT for WIRED connections between two routers! It is a wireless connection between two routers only.
A router in Client Mode connects to another wireless Access Point (the host router).
[b] It uses its wireless connection as the WAN interface [/b], and shares the internet connection only to the LAN ports.
It is not seen as an access point by laptops or other computers scanning for AP's
and does not accept wireless connections from client devices.
The main router and secondary router (client mode) are on separate subnets. NAT is used between the routers.
Thus, when port forwarding is needed it must be configured at both routers — not just on the main (host) router.
The router in Client Mode must use its own DHCP server to give out IP numbers,
Gateway and DNS server to the devices connected to its LAN ports.
@Cunami
E sad, videh na TP LINK-ovom site-u, da taj tvoj ruter ima WDS Bridge (ako sam pogodio model i verziju fiemware-a)... pa brobaj sa tim, jer nađoh i ovo:
Code:
To have computers connected to both routers (main and secondary) and co-exist in the same subnet,
set up secondary router as a Client Bridge, Repeater Bridge or use WDS.
Further explanation of bridging modes is in the Glossary.